MENG Chemical Engineering with Nuclear Technology (CPEU18) FT

2023 - 2024

For students whose initial registration was between 2017-18 and 2020-21.

Year 3

Core These are a compulsory part of your degree: you cannot change them. units (120 credits)

A student will take

Semester 1
CPE330	Systems for Sustainability	AUT SEM	15 credits
CPE337	Introduction to Fuels and Energy	AUT SEM	15 credits
CPE350	Transport Phenomena	AUT SEM	15 credits
CPE3999	Skills for Employability - Level 3	AUT SEM	0 credits
Semester 2
CPE333	Environmental Engineering	SPR SEM	15 credits
CPE360	Reaction Engineering 2	SPR SEM	15 credits
Full academic year
CPE31003	Process Design Project	ACAD YR	45 credits

A student who does not pass CPE31003 (Process Design Project) at the first attempt will be ineligible for the award of the Degree with Honours.

Year 4

Core These are a compulsory part of your degree: you cannot change them. units (105 credits)

A student will take

Semester 1
CPE450	Advanced Process Modelling, Simulation and Optimisation	AUT SEM	15 credits
CPE460	Computational Modelling	AUT SEM	15 credits
Semester 2
CPE449	Nuclear Reactor Engineering	SPR SEM	15 credits
MAT6900 XCannot be taken with: MAT4900	Advanced Nuclear Systems	SPR SEM	15 credits
Full academic year
CPE440	Research Project	ACAD YR	45 credits

Approved These are on a restricted list of modules offered by your department(s). Normally you will need to select a minimum number of credits from the list. units (15 credits)

A student will take 15 credits from this group.

Semester 2
CPE444	Petroleum Engineering	SPR SEM	15 credits
CPE451	Low Carbon Energy Science and Technology	SPR SEM	15 credits
CPE465	Energy Systems and Management	SPR SEM	15 credits
MAT6860 XCannot be taken with: MAT4861	Nuclear Waste Immobilisation and Disposal	SPR SEM	15 credits

A student must pass CPE440 (Research Project) at the first attempt in order to be eligible for the award of the Degree of MEng in Chemical Engineering with Nuclear Technology (CPEU18). A student who fails to satisfy this requirement may be awarded the degree of BEng in Chemical Engineering (CPEU02).

A student must satisfy the requirements of the General Regulations for First Degrees as to progression in order to continue as a student for the Degree of MEng in Chemical Engineering with Nuclear Technology (CPEU18). A student who fails to satisfy these requirements may be permitted by the Faculty to become instead a student for the Degree of BEng in Chemical Engineering (CPEU02).

A student must satisfy the requirements of the General Regulations for First Degrees as to the minimum number of credits at FHEQ Level 7 (not fewer than 90 credits at Levels 3 and 4) in order to be eligible for the award of Degree of MEng in Chemical Engineering with Nuclear Engineering (CPEU18). A student who fails to satisfy this requirement may be awarded the degree of BEng in Chemical Engineering (CPEU02).

⇐P	-	This module has pre-requisite(s).
P⇒	-	This module is a pre-requisite for other modules.
C	-	This module has co-requisite(s).
X	-	Some modules cannot be studied in combination with this module.
+	-	Additional information about requirements for studying this module.

Please note that the regulations displayed on this page reflect provision in 2023/24 and may not reflect study undertaken in other academic sessions. To see regulations that applied in another academic session, please return to the Programme Regulations Finder home screen and select the appropriate session.